this tool doesn't work properly, the rod assembly can't hold the tube, when you tighten the rod, there is a big deformation in the rod so that the tube comes out of the rod. I have to use a 6 inch press to close the stem and then I can make torches. The 3/16 flares have always been off center, others flare in the center. With tools like this, I still think that's not the case. not much to think about, only snapon, otc and such really professional tool makers can rely on tool flaring.
π§ Lang Tools 279-5420 279 Brake Caliper Press: The Ultimate Solution for Efficient Brake Caliper Maintenance
9 Review
π§ Adjustable Engine Cylinder Hone Tool - EWK 1-1/4 to 3-1/2 Inch 3 Stones, Deburring Piston Honer with 220 Grit
9 Review
JQuad Safety Orange Powder Caliper
9 Review
π Motive Products 0100 European Power Brake Bleeder Kit - Efficient Brake System Maintenance for European Vehicles
9 Review