Review on Belltech 3200 Drop Spindle Set by James Trapkin

A 1986 Chevy C10.1st spindle kit popped up and they looked like they had been used. Further investigation revealed that one of the spindles had a cracked caliper mounting hole. I sent them back and received the replacement set I ordered with no problems. The second set was received in just over a week and they arrived in better condition. The driver's side went with no problems. Everything is screwed on the passenger side and I cannot install the brake caliper. Inspected and found that the upper caliper bracket was not properly machined from the factory. It was too thick and the brake pads didn't slip. I had to take an angle grinder and shave off about 1/4 inch of the top tab to match the bottom one. Overall, Belltech spindles were a big disappointment. . The finished product looks very good!