Review on 🍒 PrimoChill Vue Pre-Mix (32oz) - Enhanced Black Cherry Violet by Wayne Moody

After about a week of use in my new circuit, some of the liquid giving it a cool, silky effect dissolved into a fluffy film in the clear green part the liquid . It then started to build up on the walls of my pipes and heater blocks...including the drain pipe of my tank. I even used their cleaning solution over 24 hours before filling. I contacted the seller but no response for two months. I also had to replace the pump. As I said, this was my brand new custom circuit that included this coolant so I doubt the pump will burn out in record time as I have built many circuits and never have a pump failed so prematurely. If I were to assume it clogged with the thicker of the two substances that separated; one I call bad balls and he had to work a lot harder than he should. When I replaced the pump, I noticed that the impeller's torsion bar had worn out, allowing the impeller to move up and down; This was likely caused by increased pressure on it as fluid was forced out, slowly and definitively deforming the impeller's plastic shell as well as the torsion bar without helping to reduce drag. This fluid largely caused the pump to fail exponentially after it failed itself.