
The board is not working properly. The 1st driver (DRV8825) works fine, but the 2nd driver does not send the correct signal to the stepper motor. I have replaced the raspberry pi, stepper motor and cables, the same problem keeps repeating itself. I swapped the driver. This is much worse and a waste of money.

Neural Compute Stick 2 by Intel
12 Review

π UCTRONICS GPIO Breakout Kit for Raspberry Pi Pico - Assembled Pi T-Type Breakout + 830 Tie Points Solderless Breadboard + 40 Pin Male-Female-Male Rainbow Ribbon Cable + 65pcs Premium Jump Wires
10 Review

Complete Kuman Raspberry Pi 4B 3B+ Kit: Breadboard, Expansion Board, Jumper Cables, Ribbon Cable, Resistance Pack
9 Review

CZH-LABS Electronics-Salon Prototype Shield Kit for π οΈ Raspberry Pi - Ideal for Breadboard DIY Projects
13 Review

MacBook Retina 13-inch (A1425, A1502) and π© 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review

π₯οΈ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review

M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review

Comprehensive 500pcs Laptop Screw Kit Set for π© IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review