Review on 🖨️ Upgraded 3D Printer Engraving Expansion Board Kit: Controller CNC Shield V4+Nano 3.0 Board with A4988 Driver and USB Cable - Compatible with Arduino by Moe Gilbert
Not compatible with GRBL
The microcontroller does not have enough memory to store GRBL, so it is not compatible. The pins of the stepper motor are not marked. There is no accompanying documentation, the STEP/DIR pins are swapped, which requires modifications to the GRBL library files.
- Best
- Ugly packaging
New products
Comments (0)
Top products in 🖥️ Desktop Barebones
🔌 UCTRONICS GPIO Breakout Kit for Raspberry Pi Pico - Assembled Pi T-Type Breakout + 830 Tie Points Solderless Breadboard + 40 Pin Male-Female-Male Rainbow Ribbon Cable + 65pcs Premium Jump Wires
10 Review
CZH-LABS Electronics-Salon Prototype Shield Kit for 🛠️ Raspberry Pi - Ideal for Breadboard DIY Projects
13 Review
Enhance Your Development Projects with the NVIDIA Jetson Nano Developer Kit (945-13450-0000-100)
12 Review
Neural Compute Stick 2 by Intel
12 Review
Another interesting products
MacBook Retina 13-inch (A1425, A1502) and 🔩 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review
🔧 Premium Repair Replacement Screws & Tools for MacBook Pro Retina 15"/13" - Complete Bottom Case Set
10 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review
🖥️ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review