Review on 🛠️ Exhaust Manifold Clamp Repair Kit - Fixes Broken Bolt Inside Cylinder Head (Replaces OEM 11518860) by Francisco Holmes

I received a Dorman part with an APDTY sticker over the Dorman logo.1. REMOVE SMALL HEAT SHIELD FROM BOTTOM. Three studs with 10mm nuts, one just under the steering column. Pull it straight down and back towards the exhaust pipe. There is no need to pull it out completely.2. Put a ladder in front of the truck and lie on the engine. You can stick your left and right hands in just far enough to get the top bolt into the top hole in the cylinder head. Slide your fingers down as far as you can, but not tight yet.3. Go under the truck. Lie on your back with your legs pointing backwards. Hold the bottom bolt in your left hand like you would a cigarette. Climb up and find the hole in the bottom bracket. Then move the bracket and bolt until the bolt finds the hole in the cylinder head. You can walk with it even with big hands. Tighten everything with a 14mm gear wrench or whatever you have. This can be done in 15 minutes if you don't get frustrated. Nice strong item.