Review on Automatic Transmission Pressure Switches 28600 P7W 003 by Zach Flores

Hello everyone who sees this, I hope this helps. The product is not bad, it is actually one of the most beautiful oil knives I have ever seen. They don't work though, there are two things I believe this 1 has is a small vent on the back of the connector that I believe helps the oil sensor respond. Sensor if the hole were wider they should work fine but the OEM made the hole much wider to allow the gear oil to flow faster. Why does it matter. Fluid flow and response are important as this is a 2nd and 3rd gear transmission fluid sensor on a 2001 Honda Odyssey. The oil has a fraction of a second to flow to the sensor and computer and then react to that smaller opening causing a delay of about 1 to 2 seconds delay makes shifting while riding almost impossible to feel the shift oil chambers feels a bit dry before shifting, then the shift magnet opens and fluid flows quickly to the sensor, so a smaller opening slows shifting. I correctly replaced the old sensors with these new ones along with all the new shift magnet sensors. The fluid clutch solenoid works brand new and doesn't shift and had a lag from 1st to 2nd after all my hard work I had to go back and fix the problem until I found out these holes could be causing a lag and indeed, after being out of my mind for 2 weeks i installed a clean oem transmission oil pressure sensor for 2 and transmission and boom back to normal like a new van. no more delay. I hope this helps others not to beat the product but to change the design. Grandfather. Have a nice day Matt .c