Review on 🔧 NMAZA 3 Jaw 10-Inch Hydraulic Gear Puller 10-Ton Wheel Bearing Pulling Separator 3-in-1 Pump Oil Tube Drawing Machine with M/Case by David Skyline

I was going to film with this puller on the drive/exit conveyor sprocket at the car wash the other day but I seem to have missed hitting the red record button and there's nothing. I can tell you that this would be a very short video. In fact it took longer to fit the puller, I would say 3 times longer than removing this sprocket from the hydraulic motor shaft. It was freaking AMAZING! No more tapping with a sledgehammer to loosen it a bit before starting, or better yet, turning the ratchet 1/2 inch until it finally catches and pulls, if at all. This puller did a great job removing sprockets and bearings that are tough enough to remove from anything after a long time but in a car wash environment where water, dirt, slime and mud are constant. However, the parts of the puller could be made better and more suitable for this tool, such as: It doesn't even last me a year. Those are the only issues I have with this puller and the fact that it does its job so well I barely mentioned them. Love this puller.