
I like this little hat. It technically works, but makes an unbearably high-pitched hum when the fan isn't running. A simple solution is to plug the fan into an always-on cable, but then you have to listen for a fan that's louder than my desktop. . If you're installing in a server closet, you might be fine. My application was for a touch screen, so I give it 2 stars. My touchscreen turns on (+1 star) but can only be used for the first 30 seconds as it then requires both hands to close my ears, making the touchscreen difficult to use. Maybe a bad block?

Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review

GeeekPi Raspberry Pi Cluster Case with Cooling Fan and Heatsink for Pi 4 Model B, 3 Model B+ & 3/2 Model B
11 Review

π MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review

π Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review

MacBook Retina 13-inch (A1425, A1502) and π© 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review

uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review

M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review

36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review