Review on Devonshire K 394 4 CP 2 Handle Widespread Bathroom by Jason Graham

I installed 2 in my master bathroom replacing the original 30 year old fixtures. Each faucet also required two new supply lines (I used a HIGHCRAFT CNCT1671-2 braided faucet connector with 1/2" x 3/8" brass nut, SST, 16"). The original hot and cold water valves under the sink were due to be replaced , as they are designed for copper tubing and not the flexible leads mentioned above. I recommend SharkBite 23036LFA4 Angle Check Valve, 1/2" x 3/8", Plug-in, 4-pack. You can desolder or if the tubing suffices, just cut off the old valves and just put these shark bites on the pipe, no soldering required, the only other advice needed is to use teflon tape on the end of the included stainless steel drain pipe that goes into the control section of the Drain plug is screwed in. Mine leaked without it and I had to add Teflon tape after initial installation I am very pleased with the look and quality of these faucets.