Review on OTC 7497A Rear Bearing Puller by John Goerge
Do not order this tool based on supplied specifications
Specifications state that the tool will fit axle tubes with a minimum diameter of 1-3/8" and a maximum diameter of 2-7/8" axle tube . ". The spec is incorrect. I ordered this tool based on the advertised axle tube diameter range and ended up sharpening the tool to 2-1/2" before it would fit in the axle tube. If I had to sharpen the tool 2-1/2" , how would it fit into an axle with a minimum diameter of 1-3/8"? The tool worked after the change, but I didn't need to make the change.
- Pleased
- Upgradeable
New products
Comments (0)
Top products in 👊 Pullers
🔧 Lisle 41970 Pitman Arm Puller - Heavy Duty Tool Specifically Designed for Ford Vehicles
9 Review
💪 Efficient Pitman Arm Puller: OTC (8150) Conical Design for Easy Removal
9 Review
🔧 11.5 Inch ABN Metal Relay and Fuse Remover Tool - Auto Fuse and Relay Puller Pliers for Better Automotive Maintenance
9 Review
Fully Assembled CR-V Steel 8-Inch 3-Jaw Gear Puller For Easy Removal Of Gears, Pulleys, Bearings, And Flywheels - DURATECH Gear Puller Tool
25 Review
