Review on BEP 701 KEY Battery Switches Replacement by Cody Cobbs

Awesome, although there are a few caveats. You have to drill almost every connector to make it work. Requires an abutment with a 7/16" hole, but the tabs are 3/8" straight. You will need approximately 2.5 inch long screws to flush and install the back cover. 2 inch screws will work, but you won't have enough screws to install the back cover. Most nuts you find will NOT fit in an accessible mounting nut area. The #10 bolts are the largest you can use, although the #6 nuts are the only ones that will actually fit. I bought #8 bolts and nuts, using a heat gun I heated the nuts to the point where the plastic melted and stuck them in where the nut goes in which made them somewhat permanent. I then installed the switch and bought some wing nuts to attach the cover to the back. I'm going to cut the screws about 1/4 inch so they don't stick out that much. The knob is removed by turning it counterclockwise until it stops, then depressing and turning counterclockwise an additional 1/8 turn. makes it something like a key. Revain didn't include any good pictures of this article so I added a few more. I bought this to put in a large tool box that I am using to replace the standard single battery box that is in my RV. Now I can have 2 batteries and use them to switch off between rides.