BEP 701 KEY Battery Switches Replacement Review

This is the perfect battery isolator for your RV. I set this up so I can disconnect the battery from my RV when not in use. In modern vans there is always some load when the battery is connected. A CO monitor, a different entertainment system. If you leave the battery connected and the RV sits down, sooner or later you will drain the battery. Repeat this multiple times and you will prematurely replace the battery. I have set this to disconnect everything in the camper from the battery except…

I used this to cut my RV's battery power. The goal is to prevent the trailer from draining the battery when not in use. Very easy to install on the plastic battery cover. It will take several hours if you want it to look good and if you want to install it flush. I used a dremel to cut the hole. Please make sure your measurements are correct before cutting. I was in a hurry and cut a too big hole in my existing battery box and had to buy a new one. Below is a list of what you need to get…

Awesome, although there are a few caveats. You have to drill almost every connector to make it work. Requires an abutment with a 7/16" hole, but the tabs are 3/8" straight. You will need approximately 2.5 inch long screws to flush and install the back cover. 2 inch screws will work, but you won't have enough screws to install the back cover. Most nuts you find will NOT fit in an accessible mounting nut area. The #10 bolts are the largest you can use, although the #6 nuts are the only ones that…