I have been using it for many years but this is my first self installation. My cars have always been built by professionals. But these pro's get too expensive so I wanted to try and do my MDX's rear bumper myself. Anyway, I had to cut a few times to get the design right and I finally had the design I wanted, removed the backing paper and installed, I had to reapply the foil a few times before it started to stick because they slipped over would me I accidentally got a finger smudge on one side that I can see (OCD) but that was my only mistake. I had to stretch in a few places but it's minimal. The only problem I have with this film is that it's almost permanent, you have to get it right! You can do it, just take your time and buy more because if you cut off too much or have finger smudges (sticky side) you may have to start over. Also keep your surfaces well lubricated with dish soap and water and clean the paint with a mixture of alcohol and water. Much luck!
πͺ 36-Inch 3M Door Edge Protection Film - Model 08582
9 Review
π NOCO NCP2 MC303 Oil-Based Battery Terminal Protectors, Anti-Corrosion Washers, And Battery Corrosion Pads (Pack of 2)
9 Review
πͺ Powerful Rust Remover Soak by WD-40 - One Gallon [4-Pack] - Eliminate Rust Efficiently!
9 Review
DVR Dunobil Spiegel Duo Touch, 2 cameras, black
27 Review
ReadySkin Multifunctional nanoSkin RF lifting and rejuvenation device 1 pc.
56 Review
10.2" Tablet Apple iPad 2019, RU, 32 GB, Wi-Fi + Cellular, silver
84 Review
Dunlop Winter Maxx WM01 275/35 R21 99T
28 Review
π§ Enhanced Cartman 7-Piece Automotive Oxygen Sensor Socket Set for Optimal Engine Performance
27 Review