Review on 🏍️ SunplusTrade Exhaust Motorcycle: Durable Fiberglass Stainless Steel Design by Ronnie Segobiano

I soaked the packaging for thirty minutes, emptied the bucket (which btw didn't bleed at all as happened to someone else), then started over the end of my pipe (removed) and worked forward. Overlap 0.75”. To start the twist, I folded an inch, rolled once vertically, and started increasing the angle. After two turns I installed the mounting tape. Then I rolled up and finished exactly as I started. I added 2 straps on top and 1 on bottom in total, very comfortable. I let it dry for two days and then sprayed it with black silicone spray. Let it dry for a week and install the tubes on the bike. I only used half a roll between two pipes, which in my case was 2/3 of each pipe. I just prepainted the tubes with high heat VHT matte black, so I cured the tubes for the paint, not the film. 10 minutes idle, 20 minutes cooling, 20 minutes idle, 20 minutes cooling, 30 minutes driving. They smoked and, as expected, gave off a chemical smell for the first 90 miles and bam, they stopped smoking. I was disappointed with the VHT paint job but terribly proud of the film and recommended black silicon paint (I wrapped the metal parts in cling film and taped them so the silicon paint only stayed on the film). This after 3 hours idle. It got as hot as it gets and I don't see any signs of wear or fading. It's just as warm as pipes, but the hot metal will scratch or melt rubber soles, preventing both. It can be a bit isolating, but not in the way you envision it in your head. Order a tool and extra straps, by the way only 6 are included ;)