Review on 📱 Premium Tempered Glass Screen Protector for 2020-2021 Tacoma 8-Inch Car Navigation System - Protect & Enhance Your Infotainment Stereo Display! by Kevin Harmon

Very easy installation. The best way to apply a screen protector to any type of screen, be it a computer, iPad, corner, etc. is to wipe it down with the alcohol pad provided and then go over it again with a microfiber cloth. You need microfiber as it draws dust onto the fabric and away from the screen. Remove half of the protective film and spray with warm water mixed with a little soap or windex spray. DO NOT TOUCH THE BACK OF THE SCREEN PROTECTOR. I hold the edges of the screen protector with a microfiber cloth to keep my fingerprints off of anything. Peel off the rest of the backing and spray on the protective film again. You don't have to overspray, but it's better to overspray than underspray. Spraying does two things: 1. neutralizes static electricity when you remove the protective film, and 2. helps you position or move the protective film if necessary. Press the protective film against the screen. DO NOT REMOVE PROTECTION WHEN MIXED. The backing is still damp, so gently slide it back into place. Once it's in place, take a microfiber cloth and gently press the screen protector against the screen. Work from the center to the edges, making circular movements. Wipe up any excess water or solution that drips onto your truck or device. Now leave it alone. There will be bubbles. FORGET IT. I left mine for a day. The next day, take the same rag and try to squeeze out the blisters around the edges. I had a few small and large blisters. It does not matter. Depending on your climate, you will usually find after 2-3 days that all the bubbles are gone. I have never had dust behind the screen or bubbles using this method. I installed my protector two days ago and all the bubbles are gone except for the area around the button which you can see in the photos. It's less than yesterday. I expect they will be gone in a day or so.