Review on ACDelco 15 81131 Original Equipment Conditioning by Troy Hamilton
three screws, one plug. listed.
Straightforward removal and installation. Remove the door seat and bumper side, then pull back the carpet to drop the engine after removing the three screws. You will need a universal joint or flexible shaft on a ratchet to get the rear bolt out. A piece of tape over the screw (mine is 7/32 inch) helps hold it in place to secure it in place. Connect, check motor. did. It works like a charm, nice and smooth
- Weight
- Not bad
New products
Comments (0)
Top products in 🌡️ Engine Cooling & Climate Control
Another interesting products
2007-2017 Jeep Wrangler JKU 4 Door Sunshade Mesh Top Cover - Durable UV Protection With US Flag Design - Voodonala
31 Review
820Pcs Car Push Retainer Clips & Fasteners Assortment - Ford GM Toyota Honda Chrysler BMW Benz Nissan Subaru Audi Mazda
32 Review
Replace Car Bumper Clips: GOOACC 100Pcs For Nissan, Mazda And Infiniti, Including Fastener Remover
33 Review
Upgrade Your Mazda MX-5 Miata With CravenSpeed'S USA-Made Door Bushings
39 Review