Review on 3D pen 3DPEN-2 Original plastic 10 colors x 10 meters blue stencils 70 g by Ada Wado ᠌

If we compare it to a traditional 3D printer, then it is obvious that the nozzle or thermal barrier is clogged. However, as far as I can tell, the pen does not have a nozzle or thermal barrier, which is the root of the issue. There are two plastic locks that need to be pressed with your fingers in order to remove the thermal insulation from the handle's tip. After this, the heating element and the nozzle may be assembled in a conventional manner. They might get something of higher quality for the same price. I'll use a drill to see if I can clean the nozzle on a 3D printer, and there's a good chance that it will work. until the next severe downturn. On the other hand, the design as a whole is revolting, awkward, and in no way at all well thought out (in contrast to 3D printers). The situation is nasty, the pen was purchased as a gift for a child on New Year's Eve, and the fact that it stopped working, of course, did not produce happy emotions. Well, in general, the situation is disgusting, and the pen was purchased as a gift for a child on New Year's Eve.