Review on 🔌 ARES 70039-3/8-Inch Drive Oxygen Sensor Socket - 7/8-Inch (22mm) Offset with Wire Gate Access by Brad Schaefer

I needed to replace the 02 intake and exhaust sensors on my Chevy Tracker. I bought this outlet to make my job easier. The night before when I was planning to replace the sensors I sprayed WD40 on the sensors and pipe. The next day I used this bushing and removed the top sensor that was next to the exhaust manifold. It turned out nice and easy. The downflow sensor between the muffler and the catalytic converter was a bit trickier as I had my car raised and the space around the sensor was tighter. Again, as soon as I put the connector on the sensor, it came loose with very little effort. Be sure to run the car for 5-10 minutes to warm up the pipes before removing the sensors. This outlet is built for tough use and should last a long time.