Header banner
Revain logoHome Page
William Stewart photo
1 Level
1284 Review
54 Karma

Review on Dorman 923 036 Tail Circuit Board by William Stewart

Revainrating 5 out of 5

It's easy to remove the old circuit board and install a new one. Fits great and works great.

The driver's side rear turn signal has stopped working on my 2004 Jeep Grand Cherokee. The lamp was fine, but one of the pins on the standard board was swapped and blown. I tried prying the contact but no luck so I ordered this. It was very easy to install. Heat the assembly with a hair dryer. This softened the glue without any problems. I used a small screwdriver to clean the tabs and removed the old circuit board from the taillight assembly. I applied some black silicone sealant to the groove of the new circuit board and installed it onto the taillight assembly. It fit perfectly and looked great. Old lamp sockets also work great with the new circuit board. Now my light works as it should.

Pros
  • Tail Light Assembly
Cons
  • Dim