Header banner
Revain logoHome Page
Darryl Jennings photo
1 Level
815 Review
91 Karma

Review on ๐Ÿš— 3-Inch Front and 2-Inch Rear Forged Strut Spacers Leveling Lift Kit Compatible with 2007-2019 Chevy Silverado 1500 and GMC Sierra 1500 by Darryl Jennings

Revainrating 5 out of 5

The end result of adding this kit is amazing. It lifted and straightened my 2014 Silverado.

First of all, the end result after adding this kit is amazing. He picked up my 2014 Silverado and smoothed it out (as advertised) which gave it a really aggressive look. As many others have noted, no instructions are included and customer service appears to be from China. It's very similar to other kits though, so just search YouTube and you'll be fine. A couple of issues we encountered during installation... First, on the back, the pin and hole on the leaf spring and spacer were not tightened until the U-bolts were fully tightened - it was very different from a loose one Seated on a factory block. . Also remember that the rear block spacer is not square - the shorter end goes towards the front of your truck. Second, the front struts got us into an impasse until we realized that the factory bolts are NOT evenly spaced around the strut. You will need to rotate the gasket to find the correct alignment of the bolts with the holes in the gasket. You will also need to remove the entire strut assembly as after installing the spacer you will need to rotate the strut assembly 180 degrees to fit the factory strut mounting holes. It hurts because it's difficult to align the strut bolts on the lower arm - it took some work to get them in. Lastly you will need to rotate the stabilizer down to reattach it as the spacer has been installed. Keep in mind that if you're editing one side at a time, you'll have to unscrew the other side to be able to move it. In general, I am very satisfied with the results. Total time was about 4 hours but if we had to do it again it could be reduced to less than 3 hours. Right after we were done I took it to a mechanic to have it aligned because it failed after installing this kit - which was to be expected given the need to completely disassemble its front end. For only $200 and 3-4 hours of your time you can drastically change the look of your truck.

Pros
  • Consistent test results
Cons
  • Not the best