Review on 🛠️ Creality Original 3D Extruder Assembled: Enhanced Performance with Easy Setup by Juan Castillo

Name: 🛠️ Creality Original 3D Extruder Assembled: Enhanced Performance with Easy Setup
Item: 🛠️ Creality Original 3D Extruder Assembled: Enhanced Performance with Easy Setup
Rating: 1

August 26, 2022

Works good but not as good

I bought this to replace a hot end 5 part that broke. Overall my experience was positive but I join the stars because the item I received did not match what I had replaced what was advertised. The wires are thinner. The original had thicker wires, 2.0mm OD versus 1.7mm. While this does not affect performance, it is a concern.2. Wires have no terminals. My originals had CNDZ C5 connectors for quick disconnect. The new ones were bare wires that had to be screwed into the motherboard.3. The hose was too short. They included a 13-inch hose, which is about half the size of the Ender 5. It's also too short for the Ender 3 and could have been omitted altogether.

Pros

NOZZLE TIP, ALUMINUM HEATER BLOCK, PIPE (TEFLON INTEGRATED)

Cons

Not sure

New products

Comments (0)

Please, sign in to write a comment

Top products in 🖨️ 3D Printer Parts & Accessories

Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards

4.14

19 Review

BIGTREETECH SKR 3 EZ Control Board 32Bit New Upgrade Silent Board Support EZ2209/ EZ5160/ EZ2130 Stepper Driver Compatible TFT Series Touch Screen, DIY For Most FDM 3D Printer (With 5PCS EZ2209)