Review on IQ Shield Screen Protector for Samsung Galaxy Watch Active (Galaxy Watch Active2 40mm) - 6-Pack, Anti-Bubble & Clear Film by Bobby Aghetoni

This is my first experience with a wet install screen protector. I would normally go for tempered glass, but I didn't like the fact that it adds an eye-catching layer to my watch. The instructions are quite simple and the whole process didn't take too long. As a beginner it took me about 10 minutes the first time. My second installation took a little less time. Tip: Make sure your hands are spotlessly clean and spray the solution on them as it will limit the amount of dirt/dust that can get under the protective film! (which is why I removed my first one and installed a brand new slide). Some of the advice from other reviewers is correct, it gets too slippery if you try to squeeze the solution out from under the foil. I've found that if you brush lightly on one side and make it tacky (not dry), you can center the film tightly and wash away any leftover solutions. It has also been noted that you can use your palms to hold the edges down. I did the first one and it worked, but since my palms are sweating I just ironed the edges to make sure it sticks. The foil has a pleasant stickiness, so that the edges do not open. Overall, you can't tell from my watch that there is a protective film on it! My husband even told me he didn't even realize it had a screen protector on it when I mentioned I was going to install a new one. You get 6 screen protectors which is a plus and the warranty is amazing for the price! The picture is also crystal clear (I don't know if you can see the screen protector in my photos, but it's there)! I will definitely buy from them again :)