This works, but you'll need to make a few cuts at the attachment points to make it fit. To make sure it doesn't fall off I added some washers and an exhaust pipe gasket to keep the leek out. $12 is another cost to make it fit. The only thing I didn't like was that a small ruff was cut and stickers were put on the whistle. I had to use a wire brush to sand down the decal to keep it from burning/melting. I used to just remove the muffler and drive like that, but I think it helps reduce noise in the car and pump out some heat so the bumper doesn't melt. I had it for about 2 weeks with no problems.
Gasoline generator Huter DY9500L, (8000 W)
34 Review
LEDAUT T3 Titanium Turbo Blanket Thermal Cover With Fastener Springs For Enhanced Turbocharger Heat Shielding
23 Review
TOTALFLOW 646 Mini Muffler 409SS 4.5" Round Width 4" Body 6" Overall Length Inner Inlet-3.5" Outer Diameter Outlet
39 Review
Game console Valve Steam Deck 256 GB SSD, black
59 Review
820Pcs Car Push Retainer Clips & Fasteners Assortment - Ford GM Toyota Honda Chrysler BMW Benz Nissan Subaru Audi Mazda
32 Review
25Pcs Fender Liner Screws For Toyota Avalon Camry Corolla Scion Lexus - OEM #90159-60498
35 Review
Replace Car Bumper Clips: GOOACC 100Pcs For Nissan, Mazda And Infiniti, Including Fastener Remover
33 Review
Upgrade Your Driving Experience With Lunsom'S Automatic Shift Knob: High-Quality Metal Car Shifting With Push Button & Long Stick Gear Head In Black
38 Review