Review on π§ High-Performance OTC Front Hub Installer & Puller - 7208A by Nigel Cohen
Works perfectly! Add a slide hammer for even better results!
I used this to tighten hubs on my Toyota Yaris. The hub's PCD is 4x100, the smallest you've ever seen, and it fits perfectly. The stock acorn nuts didn't reach the puller when I ran them over the studs, so I had to use wedge nuts with a deeper threaded hole to mount them onto the hub. I also used a 10 lb OTC slide hammer (7703) which pulled the hub out in about 5 hits. Simple, easy, worth the investment if you do a lot of car repairs.
- Delivery was very quick
- Not all will fit
New products
Comments (0)
Top products in π§ Steering & Suspension Tools
π§ OEM TOOLS 27213 Master Wheel Hub & Bearing Remover and Installer Kit, Back and Front Wheel Bearing Puller and Installer Kit, Back and Front Wheel Hub Puller, User-Friendly
8 Review
π§ Dorman 614-030 CV Joint Boot Tool for Easy Installation
9 Review
π§ Efficient Steering Neck Bearing Race Remover: OTC 4796 for Fast Removal
9 Review
π§ OEMTOOLS 27308 Ball Joint Separator: Adjustable from 1-1/8" to 2-1/8", Perfect for Common Ball Joint Sizes, Enhanced Steel Separator Mechanism with Black Oxide Pins
9 Review
