Review on 🔧 Mastering Precision with Stepper Controller Engraving Milling Machine by Fred Griffin

Name: 🔧 Mastering Precision with Stepper Controller Engraving Milling Machine
Item: 🔧 Mastering Precision with Stepper Controller Engraving Milling Machine
Rating: 1

August 24, 2022

Runs at low speeds, NO servo

Calling this stepper "Servo" is not correct at all. While it works fine at slow speeds (real servos don't care about speed), if you try to move the stepper at over 3000 PPS it will fail, even under a light load. Probably suitable for CNC milling, but NOT suitable for moderate speed motion control.

Pros

HSS86 two-phase hybrid stepper servo; Type: Hybrid; Frequency: 0~200KHz;

Cons

Crumpled

New products

Comments (0)

Please, sign in to write a comment

Top products in 🔌 Electrical Controls & Indicators

Vacuum cleaner KARCHER VC 3, yellow

4.36

176 Review

TWTADE/AC 24V 10A Coil Electromagnetic Power Relay 8 Pins 2DPT 2NO+2NC With Indicator Light And Socket Base -YJ2N-LY

4.51

9 Review

5Pcs 19Mm 12V 24V Waterproof Latching Push Button Switch With Wiring Harness And LED Indicator Light, Pre-Wired SPDT Self-Locking 4 Pin Marine Metal Switch For Boats Cars Trucks (Blue)