Review on HFS (R) Two Axis Welding Clamp (3''): Efficient Solution for Precise Welding Tasks by Logan Tripp

, I own Wheat State Welding LLC in Derby, Kansas. I bought four of these clips and may buy a few more. All I can say is that they are absolutely amazing, they do what they say and they do it very well. I have almost nothing bad to say about them except for the following points. They're a lot bigger than they look when you order them and they actually have more capacity than advertised. While that's great, it could have been done with a better bolt and hardware on the nut that the bolt turns on. There are some fairly loose manufacturing tolerances. It's not really a flaw, but it would be great if these clips were a little bigger, about twice the size. I have found that when clamping hoses over 2 inches in height, the hose tends to deviate in odd directions. end there with a large pipe wrench or something trying to line up your pipe with the other part to counteract the lien and then connect them together. All in all it's not a bad product and I think anyone who has bought it and used it for its intended purpose will be absolutely delighted with it. It's unbeatable in terms of price. It looks like they are probably malleable iron and actually have a machined surface, definitely someone flattened them and end milled them and did a pretty good job. I'd happily pay $60 or $70 for this clip, but for the $40 I paid for it, anyone would get a lot. And finally, if you need a corner clip, this is the clip to buy!