Review on 🌈 Geeetech Mix Color Extruder Assembly - GIANTARM 220x220x260mm by Stanisaw Augustynowi ᠌
Good value for money, I recommend.
There is a nuance with the firmware. Specifically, a version with the latest version of the board arrives from amazon, where, firstly, the drivers are soldered, that is, they cannot be changed to quiet ones, and secondly, the firmware for some reason hangs in the "Beta" status. If you ate the firmware, then take offsite marked as V2.3 and "ONLY for GT2560 V4.1", before flashing, reset the contents of its industry, sew with Kura and be prepared for the fact that you will have to sew several times until you're lucky.
- It prints well out of the box, there is immediately a seat for 3d touch, the table cover, with the correct calibration of the table, sticks models so that you can’t tear it off
- A new version of the board with soldered drivers, it was not flashed the first time
New products
Comments (0)
Top products in 🖨️ 3D Printers
🔵 IFUN 3D Быстрая смола - Низкое запах фотополимерная смола для 405нм ЖК-принтера 3D - Быстрое отверждение, стандартная жесткая формула - Небесно-голубая, 500 г
5 Review
УФ-отверждаемый стандартный фотополимерный принтер от IFUN
5 Review
3D принтер Flashforge Adventurer с съемной системой точной нивелировки.
6 Review
🖨️ ANYCUBIC Собранная инновация для офлайн-печати: совершенствуйте процесс печати с использованием передовой технологии
5 Review
