Review on 📺 Mopar 82215337 Media Center Screen Protector for Chrysler Pacifica, Jeep Wrangler, Gladiator - 8.4" Screen by Michael Hughes

I got this because it's from Mopar so I thought if ANY of them would fit perfectly then this would be the one as they make all the parts for a Chrysler car and I got this for my new Pacifica . Unfortunately, it doesn't quite match the screen. The actual screen has perfectly square corners. This protector has rounded corners leaving small gaps in each corner. Also, there is a small thin gap along the top edge and on one side, maybe 1/10th of an inch. and a slightly larger gap along the other side and bottom, maybe about 1/4 inch. hence it was not measured accurately, otherwise there would be no gaps. As for the installation. it was pretty simple and clear. However, I still ended up with 2 small air bubbles no matter what I did or tried. they just won't come out. But they're small and not very noticeable when the screen is lit. I mostly notice them when the screen is off/dim. Overall I'm mostly satisfied as even with small gaps it covers 98% of the screen and helps keep fingerprints off which is the most important thing. as the original screen was covered with prints within minutes. Dust still settles on the protective film, but at least wiping leaves no streaks and, above all, no fingerprints. My only small issue over time will be the gaps. how much dust slowly accumulates there and if it eventually lifts the tread at the edges. I hope not. but in such thin grooves this dust is more difficult to remove. While I recommend this, I wish Mopar measured and cut them more accurately to better fit their screens!