Review on ReliaPrint: Enhanced Diameter Printing Solution by Louis Asok

Disclaimer: I did not use the socket that came with it. I installed it with a two piece spring loaded anti backlash nut that fits perfectly. Runs smooth and doesn't play at all. I had to shorten mine a bit because the 300mm version wasn't available, but that didn't cause any problems. Fitting into a spring clutch for an M8 threaded rod was a little tricky but I found I could turn around. Spring coupler by threading a bolt into the "wrong" side of the outer clamp hole and pulling it over a thin metal spacer to spread the hole just enough for the T8 bolt to go in as deep as needed, then release the tension and place the set screw in the center set screw hole. Because the free side of the clamp is the only part that moves, the lead screw still stayed perfectly centered with no visible artifacts on the printed objects. Perfectly smooth walls!