Review on Upgraded Rubber Transom Saver Shocks for attwood SP-410 Models by Khaled Ribeiro

Just replaced my factory rubber pads on the bottom block on the mirror headband. Simple procedure I had to cut off three other old rubber mounts with a sharp knife, one of which was already missing, and used a grocery bag to protect them from scratches until they arrived. I simply cut the aluminum rivets with scissors, used the screws provided, and reattached them to the bracket. You will need to remove the small pivot arms to access the bolt head and nut. One more thing, one screw is shorter than the other on both sides so make sure you notice that one side is slightly thinner than the other, take note and you don't have to repeat it like I did.