Review on 🚗 Maxracing 2-inch Front End Leveling Kit for Avalanche Silverado Suburban 1500 Tahoe Sierra Yukon XL1500 by Eric Wright

So this dose of pride does what it says my truck looks great doesn't look like it's indo as it always has I gave it 3 stars because they want you to install it, it shows you take the entire front end apart so you can turn the bolts down to release the drive axle. I'm pretty sure this won't be a problem at all for 2WD. With my truck on a hoist. What I did to install this product was remove both side bolts from the bottom of the struts, then I loosened both sides for the stabilizer bar connectors as much as possible without removing them, then with the front wheels removed I have a bottom one Tool Control Used to pull the control handle down to deploy the spacer. I installed the first screw on both first on the side not under the axle in the same direction as the original screws, then I cut off the remaining two screws. the length of the original screws you cannot use as they are not fully threaded. They installed them with nuts and washers on the condition that I had to take some paint to clean the threads after trimming the bolts. Remember to re-tighten the wishbone connectors when you're done. If you don't understand what you are doing I recommend taking it to a shop to have it done.