There is no documentation for this device. I have a couple of LEDs that are already grounded and I have no idea if this will work - I don't want to try it as a check said the device was damaged due to a bad connection. If I connect it according to the label, IN-V and OUT-V are electrically connected through the LED. If that works? Will it damage the device? I could add an optocoupler and power my LEDs with +12V, but then I could just build my own circuit from scratch.
2-Inch CravenSpeed Stubby Jr Antenna For Mini Cooper Models 2001-2022 - Compatible And Optimized For Improved Search Engine Visibility.
29 Review
Short Stubby Antenna For Mazda Miata 2006-2022 - 3.8 Inch, Compatible With CravenSpeed
29 Review
WUPP Waterproof 12 Volt Fuse Block With LED Warning Indicator For Car, Marine, RV, And Truck - Includes Fuses And Negative Bus Fuse Box
27 Review
Upgrade Your Light Bar With NAOEVO 14AWG 240W Custom Wiring Harness And 6 Modes Light Bar Controller
29 Review
Gooacc 50Pcs Hood Insulation Retainer Clips - Perfect Replacement For Grand Cherokee, Dodge Ram, Chrysler PT Cruiser, Plymouth Laser, Neon - OEM Part Number: 4878883AA
33 Review
25Pcs Fender Liner Screws For Toyota Avalon Camry Corolla Scion Lexus - OEM #90159-60498
35 Review
Upgrade Your Mazda MX-5 Miata With CravenSpeed'S USA-Made Door Bushings
39 Review
820Pcs Car Push Retainer Clips & Fasteners Assortment - Ford GM Toyota Honda Chrysler BMW Benz Nissan Subaru Audi Mazda
32 Review