Review on 🌬️ Enhance Your Suspension with Arnott A-2642 Air Spring for Optimal Performance by James Nielsen

Hello, I ordered this as an international customer from the US. I drive a BMW x6 F16 x35i. I removed the 40 amp fuse from the rear fuse box 6 ton stand and then removed the passenger side cover following the installation video instructions on the Arnott website. I would recommend only removing the fuse if you have a carly or other programmer otherwise you will have to disconnect the battery or the car will report an air suspension fault and you will have to clear it. Nuts 10mm but not for complete removal, this step can be done if you have air in the balloon, if you have sagging balloons you can neglect this step, then remove the old balloon, bottom part first and form the Air suspension seat, then turn the balloon clockwise, you remove the air line, buy fittings and throw them away, you don't use the old fittings on the new one, you put the air line hose into the new long nose fittings to the end, until you feel as you reach the end, then gently pull on the air hose to ensure it stops moving. It is very important that I cleared the errors while the car was on the jacks and turned it on, but the balloons didn't work. .. . My colleague suggested putting on tires and putting the car on its wheels and all of a sudden the air compressor kicked on and I couldn't figure out why. did a test ride and i hope it lasts two years like the original.