Review on 🔒 2-Pack Black Silicone License Plate Frames: Rattle-Proof, Weather-Proof, and Rust-Proof - Ultimate License Plate Protection! by Tim Crowder

Everything is exactly as described and looks very nice. They have holes in the bottom for water to drain which is a nice touch. Inserting the panel into the lid frame was fairly easy, and they give you a tool to avoid cutting yourself on the sharp edges. It comes with enough hardware for both covers, so you can use it for both the back and the front. The screws were the same size as my old ones except the thread pitch was slightly different, which was fine in my case because they still worked as a replacement. My old screws are oxidized and the new one is painted black. You will receive square adapters if your car uses them in the bumper, if you have other screw sizes, or if you just want to change the back. In my case, the screw goes straight into the bumper, so I don't need any adapters. It also comes with end caps to further cover desired screws. Once the plate was in the lid I noticed that my plate was slightly larger than the frame so the rim was raised slightly. a page left to right and top to bottom. These are KY plates but I figured all states plates are the same size so mine are either slightly larger or the silicone frame is slightly smaller. Otherwise I could move it and make it neater. It wasn't perfect, but it still looks better and hides the sharp edge of the plate. After using new screws and adding caps at the end it looks a lot better. So be aware that it may not be exactly the perfect fit for your nameplate, but I would certainly recommend it.