Review on 4Ucam Mercedes Sprinter Van 2010 by Aaron Johnson

I just bought this unit and haven't used it yet so I'll update if I can give a good review. I assume this will work fine. It was delivered quite quickly. My mechanic did the installation as I didn't want to mess up the wiring, but the installation instructions are absolutely minimal. What you need to know: 1) Remove your existing brake light and unplug it. 2) Remove the LED strip from the existing brake light and glue it into the new block. The new unit DOES NOT have a brake light, so it retains the functionality of your brake light. 3) Run the new unit's camera power cable into the brake light area, over the top of the Sprinter and down the side to the brake light 4) Connect the power cable to the brake light power source 5) Install the WiFi transmitter in the ceiling area and make sure the camera video connections are tight/reliable 6) Connect the brake power cable to the new unit 7) Install the new unit in the Sprinter traffic light zone I called the seller and was able to speak to him direct. I found the part about removing the lightbar from the original brake assembly on another OEM website.