Review on Organize Your Wrenches With EZRED WR10-RD Magnetic Wrench Holders & Bottom! by Josh Garber
Adheres Well, stays down, best for wrenches not over 3/4 " or so.
I like these so far and currently have two holders in use, and I'm about to order a few more. Each has 12 wrenches (1/4" to 1-1/4" & 8mm to 25mm). The bottom magnets hold well to my tool chest drawers through the drawer liner. They won't move around. I My only issue is that the small magnets on the clips are not as strong. For smaller wrenches they do very well. For larger wrenches (3/4 and up with mine) they need to be balanced in the center, but do hold and keep the wrenches in order. If you're used to slamming your drawers closed you may have a problem. I found it best to orient the wrenches parallel to the front of the tool box.
- Great wrench organizer as long as you have a big wrench drawer... takes up a lot of room
- Nice tool. The magnets are not strong enough
New products
Comments (0)
Top products in 🔌 Electrical Tools & Hardware
Make Clean And Precise Holes With Adorox Heavy Duty Leather Belt Puncher - Includes Ruler And Deburring File
34 Review
🔧 Eastvolt 218-Piece Household Tool Kit: Complete Auto Repair Set for Homeowners - Hammer, Pliers, Screwdrivers, Sockets, and Storage Case
34 Review
3-Pack FOSHIO Utility Knife Retractable With 30 Degree Snap Off Blade For Vinyl, Paper & Craft Cutting
39 Review
DEKO 196-Piece General Household Hand Tool Kit - Includes Rip Claw Hammer, Lineman'S Pliers, Measuring Tape, And Plastic Toolbox Storage Case
32 Review
Another interesting products
Wireless Electronic Ballast Interface Certified
8 Review
💡 Hydrofarm Quantum QT400 Dimmable Ballast for 400W Grow Lights
5 Review
Fulham WorkHorse WH2-120-C Adaptable Ballast - 2 Pack
3 Review
🔌 Robertson 2P20132 Quik-Pak: 10 Fluorescent eBallasts for 2 F40T12 Linear Lamps, Preheat Rapid Start, 120Vac, 50-60Hz, Normal Ballast Factor, NPF, Model RSW234T12120 /A (Crosses to RSW240T12120 /B)
4 Review