They won't stick to any shirt with the right glue. Used Starbond Toughened Medium Thick CA. Superglue is for low pressure not required but once it's above 20psi I had to glue it in as the system has it set at 65psi./8" in my water flow so it lags the water temp by about 3-5 degrees but given or temperature over time matches other thermometers, including the Fluke thermocouple, to within 1Β°F. The downside is that the conversion takes anywhere from 1/8 second to 7/8 second depending on the resolution. 10-bit is best as 8-bit microcontrollers are not as accurate except in a critical application. This is due to the Dallas OneWire sensor and not having a probe or cable attached to it. This is a VERY high quality professional grade ribbon cable with a weatherproof end on the metal probe side that is pull resistant. I crimped the JST connectors on the wires just to transport them as I glued some into the reverse osmosis monitoring tees, the lack of a connector is a plus as you can use what you need with that. The wires are tinned and sturdy enough could be plugged directly into a breadboard for a microcontroller. Use with both PIC32 and Arduino and no problem.
Xiaomi iHealth Meter Thermometer White
24 Review
Cable tester BENETECH GM60
15 Review
VIVREAL 4 In 1 Stud Finder Wall Scanner With LCD Display - Center Finding Beam Finder And Sound Warning For Wood, AC Wire, And Metal Studs (Black/Silver)
24 Review
Room temperature and humidity sensor Aqara Temperature and Humidity Sensor white
25 Review
π CAMWAY 6 Inch Digital Caliper with LCD Display, Electronic Vernier Caliper, 150mm Stainless Steel Feeler Gauge, Plastic Digital Caliper Set for Zero Setting Inside/Outside Diameter, Depth, and Step Measurement Tool
3 Review
TV bracket Kromax DIX-18 black
52 Review
π Johnson Level and Tool 400EM-S 12-Inch Heavy Duty Metal Combination Square for Professionals, with Inch/Metric Measurements, Silver - 1 Square
8 Review
Kapro 307-08-TMS Try And Mitre Layout And Marking Square With Stainless Steel Blade, 8-Inch Length
18 Review