1 Level
1303 Review
34 Karma
Review on Gasher Switch Female Thread Fitting for Hydraulics, Pneumatics, and Plumbing by Ryan Brunson
Male Thread Mismatch
Threaded part too short on male end. For 1/4" NPT, the threads should mesh 3/8" and the distance from the shoulder to the end of the last thread is shorter. It will be difficult to seal properly unless a curing thread sealant is used. I changed the rating to 1 star because the low thread issue makes it useless or at least very bad in most cases.
Pros
- 180 Degree Control Handle; Double O-ring
Cons
- Expensive
New products
Comments (0)
Top products in π§ Fittings
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
3.04
10 Review
Vacuum cleaner Dreame V9 Global, white
4.35
145 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
3.24
10 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
3.86
16 Review
