Installed this on my 48v club car precedent yesterday. Installation went smoothly, using factory wiring, just adding a small jumper and then making a "Y" on the hot wire coming out of the ignition switch. One caveat, the spade connectors that come with it are rubbish. I threw them in the trash and used some good ones I had in my tool box. They seem to be working well, after a few hours of driving around the car was down to "1/2 tank". Gives some reassurance that you're not running low on juice. I'll try to verify this by measuring the voltage and comparing it to what the trojan site says for capacity.
MUCAR CDL20 OBD2 Scanner - Check Engine Code Reader And Diagnostic Scan Tool For All OBD II Protocol Cars Since 1996, With O2 Sensor, EVAP System, And Smog Test Functions
23 Review
Autoscanner for car diagnostics Rokodil ScanX Pro, OBD2 scanner
29 Review
Upgrade Your Car Diagnostics With 16 Pin OBD2 Extension Cable Splitter - Male To Dual Female Y Cable - 50CM
17 Review
Precision Bike Torque Wrench Set for Mountain & Road Bikes - Pro Bike Tool 1/4-Inch Drive with Allen & Torx Sockets, Extension Bar, Dual Readout, and Storage Box
11 Review