Review on Square Schneider Electric 9013FHG19J52X Air Compressor by Ronald Orear

Perfect. The old original Bostitch air compressor pressure sensor is shown on the left and the new replacement on the right. This pressure switch shuts off the compressor at 125 psi. It turns on the compressor when the pressure in the tank drops to 95psi or even a little earlier. This is ideal for our nail guns as they require 90psi to fire properly. The 2-way bleed valve relieves air pressure from the compressor, making the compressor easier to start or "start". When the compressor reaches 125 psi and the compressor shuts off, the release valve is depressed and the pressure built up in the compressor pump is released. To turn off the compressor I have to turn it off because that pressure switch doesn't work. It has a built in on/off switch - there are other push buttons that have this little L shaped lever on the side that toggles it on and off. If I ever need to replace this pressure switch I'll probably buy one of these that have a fixed differential of 125psi and 30psi (which means it will snap at 125psi minus 30psi = 95psi. I think I could get an EIN Put the /OFF switch on the compressor when the boys go out to lunch, but they only unplug it, so it doesn't matter How to connect the cable according to the instructions: Start from the left side of the electrical connectors and move moving to the right: 1. black wire from power cord 2. black wire from compressor motor 3. white wire from compressor motor motor 4. white wire from power cord the top of the lid stays attached to the lid so when you get it just remove the Lid and the wort stays with the lid on.