🔒 Pressure Sensor Breakout: Adafruit's Enhanced Portability Review

Seems to work most of the time, sometimes turns off and needs to be off for a while. This is the only pressure sensor I could find

Successfully integrated into Raspberry Pi used in airmast systems. The outside diameter of the connector is 0.1 inch. I installed the entire board in a section of PVC pipe and used a sealed data out connector. Works well with Arduino and PI4J. All the information you need can be found on the Honeywell website.

Plug in cable and go was easy. Average 5 -10 readings quickly and use that as your output value.The problem is that it was used for *maybe* 2 hours before it stopped working. I2Cdetect won't find it on the bus anymore, so programs won't detect it. Edit: downgraded to one star The second one I got took about 10 minutes, then crashed and gave an error saying it had "Integrity Violation" It's garbage.

Successful integration into Raspberry Pi used in airmast systems. The outside diameter of the connector is 0.1 inch. I installed the entire board in a section of PVC pipe and used a sealed data out connector. Works well with Arduino and PI4J. All the information you need can be found on the Honeywell website.

Connect and it worked without any problems. The values jumped around a bit, so it's best to take an average of 5-10 readings quickly and use that as the output value. The problem is that it worked *maybe* for 2 hours before it stopped working. I2Cdetect won't find it on the bus anymore, so programs won't see it. Edit: Reduced to one star. The second one I got took about 10 minutes and then gave an error saying it had "Integrity Violation". It's garbage.