Review on Pack Of 5 LTWFITTING Brass Barb Hose Reducing Splicer Mender Fittings For 3/8-Inch ID Hose To 1/2-Inch ID Hose - Ideal For Air, Water, Fuel & Boats by Joe Lantz
Difficult to find (sizes) hose splicing barbs.
This is a difficult to find set of sizes, And they work on an 125 PSI air line. The picture is not exact, in that ours have rounded bumps rather than the sharp edged barbs show, but they work without issue.
Pros
- fast delivery well made
Cons
- Requires Tightening: These fittings require manual tightening. It is putting too much force on them can cause damage to the hose connection, leading to leaks. This may make them less suitable for high-pressure situations
New products
Comments (0)
Top products in π§ Fittings
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
4.36
16 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
3.86
16 Review
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
3.04
10 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
3.75
13 Review
