Review on 💎 Stunning Kira Home Gemma 15" Crystal Flush Mount Chandelier: Modern Chic Design with Dimmable 4-Light & Brushed Nickel Finish by Wendy Owens

Had a chance. The first installation took 2 hours. the second took about 15 mins. read below there is a trick to align the mounting screws with the bracket. The supplied screws are a bit short. They can be leveled with a spatula or a juice straw. or you can go to your local hardware store and find screws with the same thread, maybe 1/8 longer. I used a straw reading the other person here. it's not easy yet. Pass the straw through the top of the light and align it with the screws. Then slowly press the light and if you're lucky you'll be close enough to slightly move the light and insert the screws. Then remove the straws and screw on the decorative end caps. There are NO extra crystals, so be careful when placing them. I had several quality issues with the two units I purchased. one hadn't drilled the middle to put the last middle crystal (had to drill myself with a very small drill bit) on top of the side crystals, had a whole row that had NO HOLDING CLAMPS installed on one side so the whole row was crooked and about to fall off. They gave you extra cotter pins which I used (4) to make the mounting clips for the side crystals. Also, the fiber insulation is exposed and you won't try to put it on and sweat for a while, you'll itch for a while too. of course they watch. I would buy again when they are 50% on sale. they have to work on it given the quality control issues, the lack of extra chips and the very complex setup with the wrong hardware. Much luck.