Review on MYSWEETY TB6600 Stepper Driver Controller by Carl Movahed

I bought 3 of these to drive two Nema 23 stepper motors from a GT2560 controller board for a huge DIY Corexy 3D printer. The guide was very helpful and all three drivers work perfectly. I use 2 Nema 23 for the Z axis screws and 1 Nema 23 for the Bowden extruder. The Nema 17 just wasn't strong enough to handle the heavy lifting and lowering of a massive 900 x 600mm bed. The Bowden extruder was leaking too much with Nema 17 so I upgraded to Nema 23 with this Mysweety driver. The connectors are easy to use and DIP switches are a very efficient way to change settings.