Review on ๐ Solid Brass Heavy-Duty Valve Switch by Joshua Castillo
Thread depth in ball valves
I installed these valves on the duct. I couldn't get her to stop licking, even with pipe lube and teflon tape. It turns out that the thread does not go deep enough into the valve. If you tighten the pipe it will go down and no tightening will stop the leak. I ended up cutting an eighth of an inch off the pipe to stop it from flowing.
- valves
- Big and bulky
New products
Comments (0)
Top products in ๐ง Fittings
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
