I make a lot of input devices as a hobby and so far this board has been amazing. It's very simple - just a circuit board, a couple of screw terminals and a couple of LEDs - but the form factor makes it really good. This is a fairly small board, although I wouldn't put it in the portable category as shown in the picture. Because all screw terminals are on one side, cables stay clean, and the status LEDs on each GPIO pin are great for testing. For the price I think it's worth it for a dyno or setup that has the extra space to do it. I've already grabbed a second one for a semi-permanent build!
GeeekPi Raspberry Pi Cluster Case with Cooling Fan and Heatsink for Pi 4 Model B, 3 Model B+ & 3/2 Model B
11 Review
LAFVIN Super Starter Kit for Arduino R3 Mega2560 Mega328 Nano with Detailed Tutorial - Compatible with Arduino IDE
11 Review
Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review
🌐 MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
🔧 Premium Repair Replacement Screws & Tools for MacBook Pro Retina 15"/13" - Complete Bottom Case Set
10 Review
uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review