
To be honest the instructions are a bit vague especially the part about connecting to the "CPU fan" header lol but once you understand what's going on it just works and works great. Select the PWM fan channel on your board, connect it to the controller and also to the 5V argb header, then connect all fans, connect SATA, done. I know the instructions say to hold down the button to sync to the motherboard, but I think it's just a matter of going into "just do what the argb input says" mode return to what appears to be the default. Literally just plugged in as instructed, loaded my M/B RGB software, selected effect and boom, all good. Even at full speed these things are pretty quiet and pump air and I'm one of those guys who usually put quality polar fans in builds.

Deepcool GAMMAXX 300 CPU cooler, silver/black/blue
166 Review

Unleash High-Performance with AMD Ryzen 5 3600XT Processor & Wraith Spire Cooler
223 Review

π Power Up Your Gaming Rig with AMD Ryzen 5 2600 Processor with Wraith Stealth Cooler - YD2600BBAFBOX
116 Review

Seagate Barracuda 1TB HDD ST1000DM003
93 Review

uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review

π₯οΈ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review

MacBook Retina 13-inch (A1425, A1502) and π© 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review

36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review