I finally used it today and it works fine but after doing 8 cylinders, 2 twice on Cummins the clamp was bent so 4 stars I have it just did it. in a vise, but for the price I don't think a steel hold down would do and I used a Dewalt 1/4 hex impact wrench to tighten and loosen the bolts so it doesn't feel like something that I had before because with a 1 inch bump I would buy it again just expect that I have to sit up and then hold on
MUCAR CDL20 OBD2 Scanner - Check Engine Code Reader And Diagnostic Scan Tool For All OBD II Protocol Cars Since 1996, With O2 Sensor, EVAP System, And Smog Test Functions
23 Review
Upgrade Your Car Diagnostics With 16 Pin OBD2 Extension Cable Splitter - Male To Dual Female Y Cable - 50CM
17 Review
eTORK 3/8-Inch Drive "Click Style" Electronic Torque Wrench: Precise Torque Control (25-250 In. lbs., 2-20 ft.-lb.)
12 Review
Autel AP200H OBD2 Scanner Dongle - Wireless Bluetooth Code Reader with Health Status Reports - Diagnostic Tool for Engine, Transmission, ABS, SRS - OLS/BMS Resets - All Vehicles (Android/iOS)
11 Review