1 Level
1307 Review
26 Karma
Review on Metalwork Brass Hose Barb Fitting by Alex Montgomery
Wrong size: ½ inch end is much smaller than ½ inch
The units I received were only half right. The ¼" end was the right size to fit a ¼" hose, but the ½" end was about 0.05" too small and didn't fit the ½" hose at all.
Pros
- Barbed tube seal
Cons
- Large and bulky
New products
Comments (0)
Top products in 🔧 Fittings
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
3.24
10 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
3.75
13 Review
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
4.36
16 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
3.86
16 Review
